Some Progress.

Started preparing the rear axle parts for assembly today. First up the diff carrier brackets needed the pivot shaft holes cleaning out as some paint had run in.

Round file and some wire wool sorted that out.

So now the pivot shafts can go through OK.


Using new bolts Ive temporally mounted the brackets to the diff after cleaning the paint from the mating faces.

After this I turned my attention to the lower arms and again cleaned out all the shaft holes, installed new grease nipples and bearing's.

So that's both arms ready for installation.

Its getting to the point where I can put off no longer the assembly of the rear axle, still not convinced I know what I doing though!