Not much happening.

Not much to report at the moment, no time spent in the garage for a while now. Hoping to get up there next week during my weeks holiday.
Here's the plan.
1) Fit Diff to chassis by top four mounting bolts.
2) Fit diff carrier brackets to chassis.
3) Fit diff pivot brackets loosely to diff.
4) Fit lower pivot bolts through brackets into pivot brackets.
5) Fit shims and bolt up pivot brackets.
6) Remove diff and setup on floor at required height to set geometry.
7) Install brake discs and calipers adjusting shimming to centre disc on caliper.
8) Fit hub to lower arm, adjusting the shims Ive forgotten to buy!
9) Install drive shaft to hub and ensure fully home.
10) Install drive shaft to diff output flange using camber shims to set camber.
11) Adjust toe in at this stage.
12) Fit assembly to chassis (easier than it sounds as I cant lift the diff on its own!)
13) Check toe in again.
14) Check thrust.
15) Adjust as required. (I think this is going to be the killer!)

So that's it, the plan for next Tuesday, Ive a few things to order in before then so Id best get on with it!